We are manufacturer and supplier of Ionizing Wet Scrubber to our trustable clients. Ionizing scrubber uses electrostatics to separate out particulates from a contaminated gas or vent stream. Fine particulates and aerosols in the gas are rapidly ionized and charged in an “ionization zone” and are subsequently electrostatically collected onto the surface of neutral charged mass transfer packings that are positioned in a “collection zone” that is physically isolated downstream from the “ionization zone”.
Non-plugging / non-fouling” nature of the IWS device
Since the collected particulates are continually washed, there is no fouling of the collection surfaces
This feature is of great benefit especially when the particulates are “sticky”
IWS can also enable the removal of contaminated gases from the vent stream by functioning as a packed bed scrubber
Mass transfer of gaseous contaminants from the vapor phase into the liquid phase occurs in the collection zone
Dosing chemicals into the sump enables the liquid phase contaminants to be treated
We are manufacturer and supplier of Tray Scrubber. Tray Scrubbers are a highly effective contacting device for applications requiring a low gas-to-liquid ratio. The design consists of a number of perforated trays in a vertical cylindrical tower. Liquid flows horizontally across the trays while gas flows up through the perforated tray at high velocity creating a frothing effect where the gas absorption takes place. The liquid then flows through down comer pipes to the lower trays. The number of trays can vary depending on the application and efficiency required.
Sieve trays are best suited for absorption of highly soluble but volatile compounds such as alcohols and other soluble organics as well as some acid gases. This type of configuration minimizes water usage while achieving maximum contaminant removal. Sieve trays are also less prone to plugging than packed towers and can effectively remove particulate down to 5 microns in size.
Venturi Scrubbers are used primarily for particulate size>1µ removal. The venturi throat is then designed to provide the proper gas acceleration and liquid droplet shearing to ensure adequate contact between the particulate and recycle liquid for impingement.
Fixed Throat Venturi – Model VSV:
Employed for exhaust streams containing particles having a defined size distribution.
Adjustable-Throat Venturi – Model VTV:
Similar to the fixed-throat except that the throat size and pressure drop can be adjusted by means of a movable internal bullet.
Eductor Venturi – Model EVS:
Eductor venturis are different than standard venturis in that they utilize higher pressure liquid flow to create or induce the gas flow into the scrubber. They
Rod Throat Venturi – Model MTV:
The rod or multi-throat venturi is suitable for high loadings of coarse particulate. The throat design utilizes a series of parallel rods or pipes to increase gas and liquid velocity for impingement of particulate.
We are manufacturer and supplier of Verantis Packed Bed Scrubbers. Verantis Packed Bed Scrubbers are engineered and designed to transfer soluble chemical contaminants from the vapor phase into the scrubber liquid phase where they are subsequently treated in the scrubber sump by hydrolysis, chemical reaction, biological degradation or any other chemical/physical treatment. High scrubber absorption efficiency is dependent upon the solubility of the contaminants and its vapor/liquid equilibrium and the extent to which the chemical contaminants in the vapor phase come into physical contact with the scrubber liquid phase.
We are manufacturer and supplier of Horizontal Cross Flow Scrubber. Horizontal Cross Flow Scrubbers are designed to minimize height for low-profile applications. The cross flow scrubber is highly effective for absorption of gaseous pollutants and can even handle moderate loadings of solids due to its flushing characteristics. The equipment configuration eliminates the need for interconnecting ductwork since the fan can be close coupled directly to gas outlet and access for maintenance is also convenient. For cases where more than one scrubbing solution is required, cross flow units can be arranged in series.
We are one of the leading supplier of Ionizing Wet Scrubber in the market. Ionizing Wet Scrubber used to remove both acid gases and submicron particulate. Verantis contracted to design,manufacture and install a customized scrubbing system to treat the exhaust gas from the client’s VAD and etching process.